Safety Information

The information in this manual does not include the design, installation and operation of a complete robot application, nor does it include all peripheral equipment that may affect the safety of the complete system. The design and use of the complete system need to comply with the safety requirements established in the standards and regulations of the country where the robot is installed. HUNTER 2.0 integrators and end customers have the responsibility to ensure compliance with the applicable laws and regulations of relevant countries, and to ensure that there are no major dangers in the complete robot application. This includes but is not limited to the following:

1.Effectiveness and responsibility

Make a risk assessment of the complete robot system.

Connect the additional safety equipment of other machinery defined by the risk assessment together.

Confirm that the design and installation of the entire robot system's peripheral equipment, including software and hardware systems, are correct.

This robot does not have a complete autonomous mobile robot, including but not limited to automatic anti-collision, anti-falling, biological approach warning and other related safety functions. Related functions require integrators and end customers to follow relevant regulations and feasible laws and regulations for safety assessment , To ensure that the developed robot does not have any major hazards and safety hazards in actual applications.

Collect all the documents in the technical file: including risk assessment and this manual.

2.Environmental Considerations

For the first-time use,please read this manual carefully to understand the basic operating content and operating specification.

No passengers.

For remote control operation, select a relatively open area to use HUNTER 2.0, because HUNTER 2.0 is not equipped with any automatic obstacle avoidance sensor. Please keep a safe distance of more than 2 meters when operating HUNTER 2.0.

Use HUNTER 2.0 always between -10℃~45℃ ambient temperature.

If HUNTER 2.0 is not configured with separate custom IP protection, its water and dust protection will be IP22 ONLY.

3.Pre-work Checklist

Make sure each device has sufficient power.

Make sure HUNTER 2.0 does not have any obvious defects.

Check if the remote controller battery has sufficient power.

When using, make sure the emergency stop switch has been released.

4.Operation

In remote control operation, make sure the area around is relatively spacious.

Make sure to operate the Hunter 2.0 within the visual range.

The maximum load of HUNTER 2.0 is 150KG. When in use, ensure that the payload does not exceed 150KG.

When installing an external extension on HUNTER 2.0, confirm the position of the center of mass of the extension and make sure it is at the center of rotation.

Please charge in time when the device is low battery alarm.

When HUNTER 2.0 has a defect, please immediately stop using it to avoid secondary damage.

When HUNTER 2.0 has had a defect, please contact the relevant technical to deal with it, do not handle the defect by yourself.

Always use HUNTER 2.0 in the environment with the protection level requires for the equipment.

It is forbidden to push the chassis in the parking status, and the parking can be manually released in an emergency status.

When charging, make sure the temperature is above 0℃.

5.Maintenance

Regularly check the pressure of the tire, and keep the tire pressure is maintained at 0.8bar.

If the tire is severely worn or burst, please replace it in time.

If the battery plan not to use for a long time, it need to be charged periodically in every 2 to 3 months.