Safety Information

The information in this manual does not include the design, installation and operation of a complete robot application, nor does it include all peripheral equipment that may affect the safety of the complete system. The design and use of the complete system need to comply with the safety requirements established in the standards and regulations of the country where the robot is installed. SCOUT integrators and end customers have the responsibility to ensure compliance with the applicable laws and regulations of relevant countries, and to ensure that there are no major dangers in the complete robot application. This includes but is not limited to the following：

1.Effectiveness and responsibility

Make a risk assessment of the complete robot system.

Connect the additional safety equipment of other machinery defined by the risk assessment together.

Confirm that the design and installation of the entire robot system's peripheral equipment, including software and hardware systems, are correct.

This robot does not have a complete autonomous mobile robot, including but not limited to automatic anti-collision, anti-falling, biological approach warning and other related safety functions. Related functions require integrators and end customers to follow relevant regulations and feasible laws and regulations for safety assessment , To ensure that the developed robot does not have any major hazards and safety hazards in actual applications.

Collect all the documents in the technical file: including risk assessment and this manual.

Know the possible safety risks before operating and using the equipment.

2.Environmental Considerations

For the first use,please read this manual carefully to understand the basic operating content and operating specification.

For remote control operation, select a relatively open area to use SCOUT2.0, because SCOUT2.0 is not equipped with any automatic obstacle avoidance sensor.

Use SCOUT2.0 always under -10℃~45℃ ambient temperature. If SCOUT 2.0 is not configured with separate custom IP protection, its water and dust protection will be IP22 ONLY.

3.Pre-work Checklist

Make sure each device has sufficient power.

Make sure Bunker does not have any obvious defects.

Check if the remote controller battery has sufficient power.

When using, make sure the emergency stop switch has been released.

4.Operation

In remote control operation, make sure the area around is relatively spacious.

Carry out remote control within the range of visibility.

The maximum load of SCOUT2.0 is 50KG. When in use, ensure that the payload does not exceed 50KG.

When installing an external extension on SCOUT2.0, confirm the position of the center of mass of the extension and make sure it is at the center of rotation.

Please charge in tine when the device is low battery alarm.

When SCOUT2..0 has a defect, please immediately stop using it to avoid secondary damage.

When SCOUT2.0 has had a defect, please contact the relevant technical to deal with it, do not handle the defect by yourself.

Always use SCOUT2.0 in the environment with the protection level requires for the equipment.

Do not push SCOUT2.0 directly.

When charging, make sure the ambient temperature is above 0 ℃.

If the vehicle shakes during its rotation, adjust the suspension.

5.Maintenance

Regularly check the pressure of the tire, and keep the tire pressure between 1.8bar~2.0bar.

If the tire is severely worn or burst, please replace it in time.

If the battery do not use for a long time, it need to charge the battery periodically in 2 to 3 months.