4 Precautions

This section contains some precautions for using and developing BUNKERPRO.

4.1 Battery precautions

When BUNKERPRO leaves the factory, the battery is not fully charged. The specific battery power can be displayed through the voltage display meter on the BUNKERPRO chassis rear or read through the CAN bus communication interface;

Please do not charge the battery after its power is exhausted. Please charge it in time when the low voltage at the BUNKERPRO rear is lower than 48V;

Static storage conditions: The best temperature for battery storage is -10°C~45°C; in case of storage for no use, the battery must be recharged and discharged once about every 1 month, and then stored in full voltage state. Please do not put the battery in fire or heat up the battery, and please do not store the battery in high-temperature environment;

Charging: The battery must be charged with a dedicated lithium battery charger. Do not charge the battery below 0°C, and do not use batteries, power supplies, and chargers that are not standard.

4.2 Precautions for operational environment

The operating temperature of BUNKERPRO is - 20℃~60℃; please do not use it in the environment where the temperature is lower than - 20℃ or higher than 60℃;

The relative humidity requirements of BUNKERPRO's operational environment are: maximum 80%, minimum 30%;

Please do not use it in an environment with corrosive and flammable gas or in an environment near flammable substances;

Do not store it around heating elements such as heaters or large coiled resistors;

It is recommended that the altitude of the operational environment should not exceed 1000M;

It is recommended that the temperature difference between day and night in the operational environment should not exceed 25°C;

Regularly inspect and maintain the track tension wheel.

4.3 Precautions for electrical external

The current of the rear extension power supply should not exceed 10A, and the total power should not exceed 480W;

4.4 Safety precautions

In case of any doubts during use, please follow related instruction manual or consult related technical personnel;

Before use, pay attention to field condition, and avoid mis-operation that will cause personnel safety problem;

In case of emergencies, press down the emergency stop button and power off the equipment;

Without technical support and permission, please do not personally modify the internal equipment structure.

4.5 Other precautions

Do not drop or put the vehicle upside down when carrying and setting up;

For non-professionals, please do not disassemble the vehicle without permission.