Safety Information

The information in this manual does not include the design, installation and operation of a complete robot application, nor does it include all peripherals that may affect the safety of this complete system. The design and use of the complete system need to comply with the safety requirements established in the standards and regulations of the country where the robot is installed. The integrators and end customers of BUNKERPRO have the responsibility to ensure compliance with relevant provisions and practical laws and regulations, and to ensure that there are no major hazards in the complete application of the robot. This includes but is not limited to the following:

1. Effectiveness and responsibility

•Make a risk assessment of the complete robot system.

•Connect the additional safety equipment of other machinery defined by the risk assessment together.

•Confirm that the design and installation of the entire robot system's peripherals, including software and hardware systems, are correct.

•This robot does not have the relevant safety functions of a complete autonomous mobile robot, including but not limited to automatic anti-collision, anti-falling, creature approach warning, etc. Relevant functions require integrators and end customers to conduct safety assessment in accordance with relevant provisions and applicable laws and regulations to ensure that the developed robot is free of any major hazards and hidden dangers in practical application.

•Collect all the documents in the technical file: including risk assessment and this manual.

•Know the possible safety risks before operating and using the equipment.

2.Environment

•For the first use, please read this manual carefully to understand the basic operation content and operation specifications.

•Choose a relatively open area for remote control, because the vehicle itself does not have any automatic obstacle avoidance sensors.

•Use in an ambient temperature of -20℃-60℃.

•If the vehicle does not individually customize the IP protection level, its water-proof and dust-proof capacity is IP66.

3.Check

•Ensure that each equipment has enough charge.

•Ensure that the vehicle has no obvious abnormalities.

•Check if the battery of the remote control has enough charge.

•Make sure that the emergency stop switch has been released when using.

4.Operation

•Ensure that the surrounding area is relatively open during operation.

•Remote control within the line of sight.

•The maximum load of BUNKERPRO is 120KG. When in use, ensure that the payload does not exceed 120KG.

•When installing an external extension for BUNKERPRO, confirm the center of mass of the extension and make sure it is at the center of rotation.

•When the equipment’s voltage is lower than 48V, please charge it in time.

•When the equipment is abnormal, please stop using it immediately to avoid secondary damage.

•When the equipment is abnormal, please contact the relevant technical personnel and do not handle it without authorization.

•Please use it in an environment that meets the requirements of the protection level according to the IP protection level of the equipment.

•Do not push the vehicle directly.

•When charging, make sure that the ambient temperature is greater than 0°C.

5.Maintenance

•Regularly check the tension of the suspended track, and tighten the track every 150~200H.

•After every 500 hours of operation, check the bolts and nuts of each part of the body. I Tighten them immediately if they are loose.

•In order to ensure the storage capacity of the battery, the battery should be stored with charge, and the battery should be charged regularly if it is not used for a long time.